The 22 creedmoor thread

Joined
Nov 4, 2023
Messages
82
Location
Montana
Could someone help me understand barrel contour a bit better and what would be appropriate for a 22 CM hunting build? My gunsmith uses blanks from proof research, but I could probably source from a different vendor if needed.

From what I can see on the Proof website, the stainless steel blanks for a bolt gun are only offered in M24, competition, and heavy palma. Would one of these be appropriate to use? Most of their CF barrel blanks seem to be Sendero, but I’m not sure why this isn’t an option for stainless steel or what contour I should be looking for.
Those are enormous. For hunting and steel I’d look at something like a Lilja #3 or 4
 

waspocrew

WKR
Joined
Apr 2, 2022
Messages
1,210
Location
MT
Could someone help me understand barrel contour a bit better and what would be appropriate for a 22 CM hunting build? My gunsmith uses blanks from proof research, but I could probably source from a different vendor if needed.

From what I can see on the Proof website, the stainless steel blanks for a bolt gun are only offered in M24, competition, and heavy palma. Would one of these be appropriate to use? Most of their CF barrel blanks seem to be Sendero, but I’m not sure why this isn’t an option for stainless steel or what contour I should be looking for.

Those are going to be crazy heavy for a hunting build. You could always chop and flute heavily, but it’s going to add cost. You’re better off with a lighter contour like a Bartlein 3b.
 
Joined
Nov 4, 2023
Messages
82
Location
Montana
Nice. I plan on trying that one next season. I've been using Berger 85.5 with good luck
Got any kill reports? Just ordered 300 of them yesterday, already have 600 77TMK’s waiting for the temps to get back into the 20’s/30’s before I can go shoot my new build. Using Alpha SRP brass and hopefully H1000 and magnum primers.
 

Gstew1930

WKR
Classified Approved
Joined
Jan 28, 2023
Messages
310
Got any kill reports? Just ordered 300 of them yesterday, already have 600 77TMK’s waiting for the temps to get back into the 20’s/30’s before I can go shoot my new build. Using Alpha SRP brass and hopefully H1000 and magnum primers.
Post 1298 on this thread is an antelope I killed earlier this year. So far I've taken 5 south texas whitetail & about 20 pigs. Bullet works well. I haven't tested the lower end of impact velocity. Everything over 2450 fps has died very quick
 
Top