Tactical / Precision Rifles w/WOOD

[43.6N]

100%
The brown pachmeyer is tops

 

[AMG04]

I use the Pachmayr with the basket weave texture. I think it adds that "custom" touch. I dont think they make it in brown, but my fingers are crossed!

 

[AMG04]

Seeing the brown with walnut really makes me wish I had used one on this walnut stock I carved. I didn't finish this one. It was a carve and rough sand only.

 

[43.6N]

I was nervous about the way the grain moved through the wrist, so I ended up running a 6” x1/2” oak dowel into the grip behind the rear action screw. Time will tell if that was a smart move or not. It will get covered when I bed the action.

I’m also very happy with the stipple texture. I can see why the wood Rokstok is so well loved.

 

[Nine Banger]

I found someone local who had a duplicator, and let me rent time.

How long did it take to complete this single step on the duplicator?

 

[43.6N]

How long did it take to complete this single step on the duplicator?

With me being unfamiliar with the equipment it took about 4 hours.
You have course, medium, and fine cutting bits. And you basically just trace the stock front to back with each bit.

@AMG04 is probably much faster

 

[AMG04]

With me being unfamiliar with the equipment it took about 4 hours.

No sir, I'm not any faster. I average about 4 hours per carve. I like to take my time, tape off the bottom metal inletting with a few layers of painters tape. Follow the edges, check fit, remove a layer, check again. Basically sneak up on the fit I want.

Most of my templates have pretty large barrel channels, so I also use transfer ink and carve those with a barrel channel inletting tool. Gradually dropping the barrel in. Then, sanding with the barrel in place for perfectly even clearance.

 

[RockAndSage]

First coat of tung oil just went on. I feel like a proud fatherView attachment 963782View attachment 963783

I might have missed you covering this, but just in case, be sure to seal the end-grain wood underneath the recoil pad. The slightest bit of moisture getting between the wood and the end plate will swell the grain up, sometimes pretty bad.

 

[43.6N]

I might have missed you covering this, but just in case, be sure to seal the end-grain wood underneath the recoil pad. The slightest bit of moisture getting between the wood and the end plate will swell the grain up, sometimes pretty bad.

Yessir.
Waterproof cement under the pad covering all the endgrain

 

[huntsman22]

If I had some wood, a duplicator and a modicum of you guy's skill, I wouldn't have to buy MDT TimbrCores and Woox's.....

 

[43.6N]

If I had some wood, a duplicator and a modicum of you guy's skill, I wouldn't have to buy MDT TimbrCores and Woox's.....

How are you liking the timbr?
Their hunter bottom metal caught my eye recently

 

[huntsman22]

I like them a lot. Just wish they were oil finished instead of whatever sealer they use on 'em....