Suppressor on a 24 inch barrel?

[Echo]

My X bolt has the exact same barrel in my 6.8W Mountain Pro. Although I worried the can would negatively affect accuracy, it is more accurate with the can (significant POI shift). I use a SilencerCo Ebo, but am saving up for the Scythe.

It is not as unwieldy as I expected because my Mountain Pro is very light. Great for open areas and blind hunting.

NOTE: X bolts have metric threading. You will need to purchase a direct thread mount to match the threading.

Great note regarding the x-bolt threading…thanks!

 

[3gunyotehtr]

My primary rifle has a 27" barrel, and using a backcountry suppressor with it have never had an issue or wished for a shorter barrel. I would rather have the extra velocity and run a milder load.

 

[turbobrick]

good feedback…..I actually didn’t realize a shorter barrel would be louder. I knew it hurt velocity and energy a bit but the noise increase is interesting.

All things being equal, a longer barrel will be more quiet than a shorter one. Is it something you'll notice 20" versus 24"? Probably not. 16" versus 24", yeah you'll hear that difference. My 24" 300wm was so mild it was crazy though, I loved hunting with that thing.

 

[rclouse79]

I just ordered a threaded 24 inch barrel in 25-06. Everything I read said that caliber is being short changed with a short barrel. I will get a 6 inch suppressor. I did get an xlr folding stock, which I think will negate the suppressor and barrel length when on my pack. I also don’t think it will be bad in my gun bearer.

 

[JF_Idaho]

The only thing worse than a 24" barrel with a supressor is a 24" barrel without one.

I say good to go.

 

[Echo]

The only thing worse than a 24" barrel with a supressor is a 24" barrel without one.

I say good to go.

Well said!

 

[Brucebarker024]

I hunted with one this year. 24 inch barrel with a DD LTI. About 32 inches of barrel length. I used a Kifaru gun bearer and had no issues. I’ll go shorter with the next barrel but I’m gonna shoot this one out first.

 

[omicron1792]

I hunted with one this year. 24 inch barrel with a DD LTI. About 32 inches of barrel length. I used a Kifaru gun bearer and had no issues. I’ll go shorter with the next barrel but I’m gonna shoot this one out first.

Why not just chop it?

 

[Shortschaf]

Use it at 24" and see if you notice. Can always chop later.

I did that and ended up doing the chop. Wasn't that bad to use the rifle at 24"+can, but I didnt lose a meaningful amount of velocity by chopping either.

 

[Brucebarker024]

Why not just chop it?

It’s a carbon tube. Otherwise I would.