I decided to just make my own. Here is the process which was pretty simple. Ordered 1/2" thick polyethylene sheet off amazon for $6.99
I pulled my limbsaver pad off and just traced it with a sharp pick for the outline. I used a jigsaw to cut it which got me very close to the point I was able to hand sand it down. I marked and drilled the holes to line up with the pad holes. Found some 1/2" longer screws I had to use. Hit it with some clear coat on the sides to hide some fine lines. Overall turned out alright if you need a little longer LOP. I had everything except the polyethylene so only cost me 7 bucks. Only weights 1.9 ozs
Also the sheet is big enough to get atleast 3 out of it. So roughly $2.50 each if you have all the other material.
I pulled my limbsaver pad off and just traced it with a sharp pick for the outline. I used a jigsaw to cut it which got me very close to the point I was able to hand sand it down. I marked and drilled the holes to line up with the pad holes. Found some 1/2" longer screws I had to use. Hit it with some clear coat on the sides to hide some fine lines. Overall turned out alright if you need a little longer LOP. I had everything except the polyethylene so only cost me 7 bucks. Only weights 1.9 ozs
Also the sheet is big enough to get atleast 3 out of it. So roughly $2.50 each if you have all the other material.
