SRS Tikka 20 moa rail

[blacktailcentral]

I have 2 tikkas with the srs 20 moa rail and have had issues with torquing the rail to the action with the T10 screws. When torquing down the bits can’t handle the recommended torque. Anyone else have this issue?

 

[The Harbor Master]

Watching... I have used the Area 419 rails but am eyeing the SRS for the next rifle.

Edit... are the bits having issues? Or are you stripping the screw heads?

 

[wind gypsy]

You cant get them to take 15 in/lbs? That is pretty light.

 

[blacktailcentral]

Watching... I have used the Area 419 rails but am eyeing the SRS for the next rifle.

Edit... are the bits having issues? Or are you stripping the screw heads?

Bits are twisting, this is with a wheeler fat wrench

 

[blacktailcentral]

You cant get them to take 15 in/lbs? That is pretty light.

I agree very light, from my initial research most t10 torque bits are rated to about 10-15 inch pounds. So maybe they need t15 to handle the necessary torque

 

[NWBLKTAIL]

Bits are twisting, this is with a wheeler fat wrench

I’ve had that happen use better bits

 

[WeiserBucks]

use better bits

This ^^^^^^

 

[blacktailcentral]

I’ve had that happen use better bits

Any recommendations on bits, have tried milwaukee and a few others with the same results

 

[WeiserBucks]

Any recommendations on bits, have tried milwaukee and a few others with the same results

I've got a set of Blue Point bits that I've used for 15+ years and never boned one.

 

[Macintosh]

I had this issue with a rail a while back, dewalt bits were just crumbling at less than 15inlb. I tried a bunch of bits and finally managed to get the screws in but clearly the t10 bits are too small if the majority of bits i tried didnt work. Its frustrating to say the least. I ended up swapping that rail out to a different one (not because of this) that had larger bits, so problem solved.

Fwiw im fairly certain it was an area 419 rail that I had the issue with. Perhaps you can get ahold of the same screws with a t15 head?

 

[The Harbor Master]

Wow. I've seen bits deform a bit but never at that low torque. Maybe I just haven't noticed. You'd think Milwaukee bits would be fine...

 

[The Harbor Master]

Can you source screws with the same dimensions but as T15 or T20?