Slick Trick broadhead sharpener

[kpbrown31]

What are you all using? KME?

Maybe I should just buy new blades, but I feel wasteful not re-sharpening all of the blades I have laying around, when 75% haven't been shot and are only dull from sliding around in a broadhead box I have.

Thanks!

 

[Trial153]

KME would work just fine. So would most any jig for that matter

 

[dtrkyman]

Stay sharp and some wet sand paper.

 

[Ches]

I know this is an old thread, but you can sharpen Slick Tricks sharper than they came from the factory. I have always matched the factory angle with the Black Stay Sharp sharpener. I use wet/dry sandpaper (dry) starting out at 320 then working my way up 400/80-0/1500/3000/back side of fiberboard (beer case) with some white compound on it. The only time I toss them is if they bend or get big ding in them. I use a Plano 3700 box with holes drilled into dividers just smaller than the BH screw size. I screw them into dividers, one
facing each way then put them back in box compartment slides. Broad heads don't touch anything and a securely stored. You can get about 24 heads in each box.