Show your Tikka ten round groups

[Q_Sertorius]

I tried out a variety of factory ammo in my 16.1” Tikka with 1:10” twist. It shot the ADI 55- and 69-grain bullets exceptionally well.

And it turned out some very nice groups with the Frontier 5.56 62-grain loads.

 

[Jmedin]

These are two groups on a 20” 6 Dasher I’m working up a load for

 

[Lawnboi]

6 dasher last match of the year 10 shot zero

 

[Styer22]

Factory older lot of AAC 77TMK. 10 shot group out of a newer factory threaded 223 20” stainless tikka. Adjusted zero after this.

 

[Q_Sertorius]

Replaced the stock and went out to check zero. I’d say she’s still zeroed. Tikka T3 stainless .223

ADI 55-grain

 

[FaaSamoa]

Tikka T3x Lite 223 w swfa 3-15

These are two groups I show using 62g Bonefrog Range Line ammo.
I’m pretty new to shooting , first shot group of 9, adjusted up 2 mils then shot the group of 13. I believe the red dot is an inch or half inch diameter

This is at 100 yds. Any advice would be welcome, felt pretty good shooting these from bench with rear rest being a rolled up pair of pants. Does this dispersión say anything about what I could improve on? Maybe rifle doesn’t like ammo either?

 

[BCsteve]

Try different ammo. Your Tikka should be able to do better than that.

 

[Q_Sertorius]

Agreed, try different ammo. My Tikka didn’t like the Bone Frog. Try one of the ADI loads. This is your first group measured using Ballistic-X.

 

[Q_Sertorius]

View attachment 938121View attachment 938122
Tikka T3x Lite 223 w swfa 3-15

These are two groups I show using 62g Bonefrog Range Line ammo.
I’m pretty new to shooting , first shot group of 9, adjusted up 2 mils then shot the group of 13. I believe the red dot is an inch or half inch diameter

This is at 100 yds. Any advice would be welcome, felt pretty good shooting these from bench with rear rest being a rolled up pair of pants. Does this dispersión say anything about what I could improve on? Maybe rifle doesn’t like ammo either?

That appears to be a 1” dot. If you pulled the bottom round in the first group, it’s not a horrid group, but I expect it is just how your rifle shoots that ammo.

 

[FaaSamoa]

That appears to be a 1” dot. If you pulled the bottom round in the first group, it’s not a horrid group, but I expect it is just how your rifle shoots that ammo.

Sweet thanks guys. I’ll try some other ammo and post some updates

 

[Frozenlead]

T3x 6.5cm 20shot from the other day
Factory 147eldms

 

[Q_Sertorius]

Sweet thanks guys. I’ll try some other ammo and post some updates

Shooting from a bench, a decent shooter should be able to get a 1.5” group from a Tikka with factory ammo it likes. And with ammo it really likes, you should be able to get around 1”.