SAC bushing in Redding die making decap pin too short

[jikkyo]

Not sure if I’m just not setting it up right. I have a SAC bushing in my Redding Type S FL sizing die.

When I set it up, the decapping pin only sticks out slightly from the body of the die and does not push spent primers out during the sizing process.

Any idea what’s going on? I’ve read these are supposed to be compatible with Redding.

 

[Erict]

I just measured my Redding bushings - they are .500 OD and .375 high. I think this is identical in size to what SAC bushings are.

I suspect you will figure it out by rechecking your die setup and, if necessary, rereading the paper instructions supplied with your dies. Good luck.

 

[eric1115]

Decapper in type s dies has a threaded rod so you can adjust pin depth.

Loosen this collar, and you can run your decapper down. Retighten (it acts like a lock nut) and be on your way.

 

[deadwolf]

I take all the decap stems out of my Redding dies and decap in a separate step. Problem solved


Sent from my iPhone using Tapatalk