Jun 26, 2012 #1 Brandon Pattison WKR Joined Feb 25, 2012 Messages 2,829 Location Michigan Pre-cut. V-block, C-clamp and die grinder. Angle block, V-block and C-clamp (on a bias to prevent kickback). Micro-adjust. 3" V-block, C-clamp, 5/16"-18 socket head cap screw and jam nut. Post cut.
Pre-cut. V-block, C-clamp and die grinder. Angle block, V-block and C-clamp (on a bias to prevent kickback). Micro-adjust. 3" V-block, C-clamp, 5/16"-18 socket head cap screw and jam nut. Post cut.
Jun 26, 2012 #2 Titaniumman Lil-Rokslider Joined May 29, 2012 Messages 251 Location N.W.Montana I must agree with your assessment of this device sir.
Jun 26, 2012 Thread Starter #3 OP Brandon Pattison WKR Joined Feb 25, 2012 Messages 2,829 Location Michigan It works really good though. Every time my dad and I (retired machinist) do this we scratch our heads for 10 minutes trying to remember how to do it again. I have been meaning to buy one of those handy dandy machines.
It works really good though. Every time my dad and I (retired machinist) do this we scratch our heads for 10 minutes trying to remember how to do it again. I have been meaning to buy one of those handy dandy machines.