sndmn11
“Daddy Zoltar”
I shot one of these, a Prime Divide, at WHCE this year, it might have been the first prime bow I have shot, and I couldn't find anything to complain about in the 6' bow "test". I ran into @robby denning that same day, mentioned I'd give one my normal long term tuning and score focused review, and here we are. https://www.g5prime.com/divide/
It showed up last night. I have been told by Prime that these carbon/aluminum joints have been tested to hang 8,000lbs without failure, and literally, "beat the crap out of it". <---that's a genuine bonafide direct quote
I just wanted to make sure I could hang the bow up like this...
The Divide comes in 31", 33", 35", and 37" axle to axle choices, and very uniquely, a 6" or 7" brace height choice. I chose 35"ATA and 6"brace, Morel colored riser with Bottomland limbs.
I've got 4.38lbs bare bow with limb dampers and tags still on.
Integrated arrow rear and picatinny sight mounts, as well as the standard threaded holes for both.
I didn't know this until I asked Prime at WHCE and shims and tuning; Prime holds the patent for clip in shims, and licenses it out to another bow manufacturer. Prime applies their patent to the Divide by using clip in aluminum shims.
In my box was another mod/draw stop that I need to read the manual about, and two alternate sets of shims.
I'll use this through the summer, tuning and fiddling, shooting 3d league, and possibly beating the crap out of it.
Let me know what you want to see done or what questions you have.
It showed up last night. I have been told by Prime that these carbon/aluminum joints have been tested to hang 8,000lbs without failure, and literally, "beat the crap out of it". <---that's a genuine bonafide direct quote
I just wanted to make sure I could hang the bow up like this...
The Divide comes in 31", 33", 35", and 37" axle to axle choices, and very uniquely, a 6" or 7" brace height choice. I chose 35"ATA and 6"brace, Morel colored riser with Bottomland limbs.
I've got 4.38lbs bare bow with limb dampers and tags still on.
Integrated arrow rear and picatinny sight mounts, as well as the standard threaded holes for both.
I didn't know this until I asked Prime at WHCE and shims and tuning; Prime holds the patent for clip in shims, and licenses it out to another bow manufacturer. Prime applies their patent to the Divide by using clip in aluminum shims.
In my box was another mod/draw stop that I need to read the manual about, and two alternate sets of shims.
I'll use this through the summer, tuning and fiddling, shooting 3d league, and possibly beating the crap out of it.
Let me know what you want to see done or what questions you have.
