Titanmoose
FNG
- Joined
- Sep 7, 2023
- Messages
- 57
This is my Rem700 that has been swapped/ fitted to 7prc. (Was a 7 rem mag)
My dad did some custom work on the bottom side of action and the finish was chewed up overall.
I’m torn between a basic brownells rattle can with their fancy spray paint.
Stripping it and polishing the whole thing to a shiny finish (lots of work)
Or an at home duracoat finish. Better than Brownells but not sure it’s that much more durable for 50 bucks more….
Not in love with the idea of sending it off for cerakote considering it’s literally just the action body I’m concerned about. Cost =benefit isn’t there for me
Also, any insight/tips and best equipment to polishing the rails and inside the action. It could use some cleanup, and would probably be beneficial to the MackBros upgraded Bolt for smoothness.
Love any insight if polishing the action body is even feasible and if so, all the advice is welcome.
My dad did some custom work on the bottom side of action and the finish was chewed up overall.
I’m torn between a basic brownells rattle can with their fancy spray paint.
Stripping it and polishing the whole thing to a shiny finish (lots of work)
Or an at home duracoat finish. Better than Brownells but not sure it’s that much more durable for 50 bucks more….
Not in love with the idea of sending it off for cerakote considering it’s literally just the action body I’m concerned about. Cost =benefit isn’t there for me
Also, any insight/tips and best equipment to polishing the rails and inside the action. It could use some cleanup, and would probably be beneficial to the MackBros upgraded Bolt for smoothness.
Love any insight if polishing the action body is even feasible and if so, all the advice is welcome.
