Nock low help

[Billy Goat]

At rest or full draw?

Cord is on front side of cable or side facing riser. With a 1/4” tail rest comes up a little after half way through draw cycle. With burnt ball it comes up in last 1/3 to 1/4 of draw cycle

Cables shouldn't be twisting in draw cycle, so it shouldn't be changing from at rest to full draw, you want it facing the riser the whole time.

Should be 2 white hash marks on the rest, one on the body, one on the thumb cock. That's what I'm asking about position.

If you are cooking the rest, and then halfway through the draw cycle it is coming from cocked position, to the full upright, 90 degrees, it's got way too much tension. That should only be happening in the last few inches of the draw cycle, like 2, maybe 3".

 

[MT257]

I’m baffled by this, but I took replacement strings off set it to spec with factory strings. Still with 28” mods. Still had nock low. I then realized prior to the string swap I had the #3 mods at 28.25”. That’s where it was tuned prior to swapping strings and shot great. Could it really be a mod? Go and have the #3 mods put back on and shoot it through paper. I was kinda in shock but after three shots this was my final tear. Still maybe a little nitpicking left but I’ll take it. Never thought it could be a mod? Anyone else seen anything like this before?

 

[Billy Goat]

I’m baffled by this, but I took replacement strings off set it to spec with factory strings. Still with 28” mods. Still had nock low. I then realized prior to the string swap I had the #3 mods at 28.25”. That’s where it was tuned prior to swapping strings and shot great. Could it really be a mod? Go and have the #3 mods put back on and shoot it through paper. I was kinda in shock but after three shots this was my final tear. Still maybe a little nitpicking left but I’ll take it. Never thought it could be a mod? Anyone else seen anything like this before?View attachment 873882

Mislabeled mod?

I have seen mislabeled blades for target rests.

 

[MT257]

Mislabeled mod?

I have seen mislabeled blades for target rests.

I have no idea. I would have never guessed the mod was the issue.

 

[Billy Goat]

I have no idea. I would have never guessed the mod was the issue.

Chit hapoens.