Newbie Help - tight bolt after FL sizing when chambering

I’ll check in there tomorrow! Obviously something is different though because it definitely fixed my issue
You really should get a comparator/headspace gauge and be measuring, right now you don't know what changed or how much. If you want good results from reloading it's important, it's down to thousandths that make big differences.
 
Actually I got that wrong, it has an influence but the critical measurement is this one
0.125” is the standard View attachment 916002

Its actually all of those measurements. The overall could change and adjust where the brass is located in relationship to the die. However, screwing the die in until there's a cam over point should fix it regardless.

The answer is a comparator set. You're pissing in the wind trying to diagnose without one.
 
Back
Top