New Reloader Looking for Help on Fire Forming New Brass for 7mm-08

[Kimber7man]

Or you could just buy some Ramshot Big Game, load 47 grains under a 139 or 140, large magnum rifle primer, and commence to killing stuff.

 

[Notorious BEN]

Or you could just buy some Ramshot Big Game, load 47 grains under a 139 or 140, large magnum rifle primer, and commence to killing stuff.

I plan on buying some of that and Ramshot Hunter to try out, but want to focus on other powders first.

 

[HandgunHTR]

I plan on buying some of that and Ramshot Hunter to try out, but want to focus on other powders first.

Hunter is too slow. You can skip that one.

For the 7-08, stay between Varget and 4350 on the burn rate chart.

 

[WhoGarrDen]

Hunter is too slow. You can skip that one.

For the 7-08, stay between Varget and 4350 on the burn rate chart.

When looking at Nosler's reloading data, Hunter is showing up as having some of the higher MV's in 150- and 160-grain range. It's pretty neck and neck with RL19, which holds its own against Big Game in other comparisons. Am I missing something? NOTE: Hunter is constantly showing load volume of >100% in most loads...could be a down side?

 

[Harvey_NW]

NOTE: Hunter is constantly showing load volume of >100% in most loads...could be a down side?

That's at SAAMI length, scooted out closer to the lands it might actually be optimal for case fill and ignition.

 

[Notorious BEN]

Hunter is too slow. You can skip that one.

For the 7-08, stay between Varget and 4350 on the burn rate chart.

The Hunter was more for my 243 where I would be loading a heavy for caliber bullet.

 

[HandgunHTR]

When looking at Nosler's reloading data, Hunter is showing up as having some of the higher MV's in 150- and 160-grain range. It's pretty neck and neck with RL19, which holds its own against Big Game in other comparisons. Am I missing something? NOTE: Hunter is constantly showing load volume of >100% in most loads...could be a down side?

That's at SAAMI length, scooted out closer to the lands it might actually be optimal for case fill and ignition.

I have been loading the 7-08 for a long while now and trust me when I say, if you have a SAAMI chamber you will run out of case volume long before you get to the top end velocities with just about any powder slower than 4350/Staball. Especially with the heavier bullets.