Are there any Tikka stocks that can use factory and AICS mags?

[gtriple]

I’m trying to figure out if there’s any stock that I can switch the bottom metal and use factory mags or AICS mags. I’ve got a 7PRC Tikka that I want a new, heavier stock for, but I’d like to get something I can swap to a short action AICS setup for competitions.

 

[RockAndSage]

Doesn't Tikka's CTR stock use AICS mags?

 

[LongWayAround]

Doesn't Tikka's CTR stock use AICS mags?

No

 

[Q_Sertorius]

I’m trying to figure out if there’s any stock that I can switch the bottom metal and use factory mags or AICS mags. I’ve got a 7PRC Tikka that I want a new, heavier stock for, but I’d like to get something I can swap to a short action AICS setup for competitions.

I have been considering this one:

TIMBR CORE Rifle Stock – Rifle Chassis | MDT

No Two Stocks Alike — MDT's precision hunting chassis, built for performance. Fits Remington 700, Savage, Tikka T3/T3x. 4.8★.

mdttac.com

I haven’t asked or researched how interchangeable it is, but it uses AICS msgs with at least one set of bottom metal.

 

[sndmn11]

Atlas and Red Snake both have aics bottoms for factory inlets. So, if either of those are good, your answer is at least any stock with a factory bottom inlet.

 

[schmidty3]

I’m trying to figure out if there’s any stock that I can switch the bottom metal and use factory mags or AICS mags. I’ve got a 7PRC Tikka that I want a new, heavier stock for, but I’d like to get something I can swap to a short action AICS setup for competitions.

Just FYI...

Waters does have 8 rd mags for magnums. Im using a 300 win magazine for my 25 prc. I did need to file it a bit to present the rounds appropriately.

It was a cheaper route then buying another BM.

It works fairly well. But tinkering was necessary.

 

[UPThunderbolt]

According to their literature, Boyd’s stocks should accommodate AICS. I just put one of their laminated stocks on my .300 wm. I really like it.