New Kimber Mountain Ascent 799 bucks

What length did you cut it down to? I have one and thought about 20” threaded to put a can on it. Mine is crazy accurate with 285gr and it’s a fun gun to slam animals into the ground.
Went 20” and threaded 5/8-24. Had him re drill and tap for the front iron sight but removed the irons. Used plug screws in them and kept irons off to cut some more weight as I’ll never honestly use them. It really helps with the balance a lot and makes it feel way more handy/swing better. Highly recommend the chop on it I mean yes a 375hh doesn’t get ballistics like a 375 Ruger does with a short barrel but no animal will ever notice the small difference.
 
Sounds like we need to start a Kimber Addicts Anonymous group.

If any wives give you boys a hard time about your recent Mountain Ascent purchase, simply show her this photo and say "see, at least I'm not like this guy"

Works every time, 60% of the time.

1000013386.jpg
 
Ok boys, looking for advice/suggestions. I picked up a 6.5cm and .308 and I’m going to chop one of them. Which one and how short should I go?
 
Ok boys, looking for advice/suggestions. I picked up a 6.5cm and .308 and I’m going to chop one of them. Which one and how short should I go?
Chop the 6.5 to 18.

New +Peak ammo and an OTB can is gonna be one bad mama jama, that's what I'm doing with mine

If anyone needs mockups of what different lengths look like, hmu. Mine go from 16.25 to 24" with everything in between
 
Ok boys, looking for advice/suggestions. I picked up a 6.5cm and .308 and I’m going to chop one of them. Which one and how short should I go?
6.5 Creedmoor: Cut and thread at 16.5 inches. You'll thank me later.
.308: Rebarrel with an 18-inch .22 Creed or SBR it and go 12.5 inches. That would be handy rifle.
 
Back
Top