My first Tikka

[wind gypsy]

Is it a smart idea to upgrade the recoil lug on these rifles with the mountain tactical bombproof recoil lug? Or is it not really necessary? I'm not trying spending more money on this rifle, but If its highly recommended, I will grab one..

https://www.mountaintactical.com/shop/tikka-t3t3x-bombproof-recoil-lug

Definitely not. I think the mountain tactical lugs are more likely to be a downgrade than an upgrade vs what comes with a T3x. The prior gen T3 used aluminum recoil lugs that could deform over time with use.

 

[Kylenautique]

Definitely not. I think the mountain tactical lugs are more likely to be a downgrade than an upgrade vs what comes with a T3x. The prior gen T3 used aluminum recoil lugs that could deform over time with use.

Good to know. I was thinking about changing it out when I cerakote the barrel. I will leave the stock lug.

 

[Kylenautique]

Since you didn't mention it - you'd need a 308 barrel and that's really all you'd NEED to turn a 30-06 into a 308. 308 might feed ok from 30-06 magazine and you'd just have a slightly longer bolt travel than necessary without swapping bolt stops.

Gotcha. I thought the barrels were the same between the two. This is not something I was going to mess with. It was just a thought... I already have a tack driver 308

 

[wind gypsy]

Gotcha. I thought the barrels were the same between the two. This is not something I was going to mess with. It was just a thought... I already have a tack driver 308

Rifle Chambers are machined into the barrels and the chambers need to fit the cartridge within thousandths of an inch. 308 and 30-06 ammunition is not close to the same size.

An Introduction to Rifle Chambers

An introduction to match rifle chambers and the features that matter.

bisonballistics.com