Maven .6 LPVO Newest Newer New Model

sndmn11

"DADDY"
Joined
Mar 28, 2017
Messages
10,216
Location
Morrison, Colorado
Whelp, I'm at a stand still. Before hitting 18inlbs, either the tapped portion or the screws of the Warne Hyperlite rings stripped on 4. The shavings that came out with the screws would make one think we were a machine shop.
PXL_20241104_190146016.jpgPXL_20241104_190624620.jpgPXL_20241104_190405948.jpg
 
  • Wow
Reactions: NSI

sndmn11

"DADDY"
Joined
Mar 28, 2017
Messages
10,216
Location
Morrison, Colorado
Hyper lite looks like Hyper junk
I had a 30mm set on that crs3 and pulled them off to check everything. They seemed fine and I switched them over to a NF scope to test later on.

The 34mm shown above, 4/8 tapped holes stripped before 18inlbs was reached. The stripped holes are all on the opposite side of the rail clamp. Warne said they have had a few in 34mm pop up with that issue and I have tracking for a new set already. The tapped rail clamp holes and the cap holes above those were solid when hitting the prescribed torque values.
 
Top