Match Master seating dies Question

[stormthelab20]

I reload for 300 Win, and use a set of Match Master dies. I'm having a 300 PRC chambered as we speak. Would there be any reason I couldn't use this seating die with both cartridges and just get a PRC F/L bushing die? Of course, RCBS says they are caliber-specific.

Also any suggestions outside of RCBS MM line that you guys suggest for 300 PRC F/L bushing die? RCBS only sells the MM dies as a pair..

 

[waspocrew]

Just run it through the die and see if it works - I suspect it will. I used their 22 Creed MM seater for my 22-250 AI without any issues at all. I would think the same for 300 PRC and 300 WM.

For a FL bushing die, I tend to use Redding for the most part.

 

[stormthelab20]

Just run it through the die and see if it works - I suspect it will. I used their 22 Creed MM seater for my 22-250 AI without any issues at all. I would think the same for 300 PRC and 300 WM.

For a FL bushing die, I tend to use Redding for the most part.

Sounds like a good idea, thank you.