I'm curious how much margin of error everyone uses when calculating how much fuel to bring on a backpack trip. In the past I've always just packed one of the larger 227 gram MSR canisters and it's been more than enough for my trips. I'm trying to shave some weight for an upcoming hunt and could drop about 7 oz if I can get by with the smaller 110 gram MSR canister.
My hunt will be first week of Sept for 8 days at about 12,500'. My current stove setup is a Soto Windmaster Triflex (2.75 oz) with a MSR Titan Kettle (4.80 oz). The stove burns approximately 6.5 grams of fuel to boil 2 cups of water (1500' elevation, 70 degree, no wind) and I boil 2 cups twice per day. This would put me using 104 grams of fuel with no loss factor for wind or temp. Is trying to get by with a single 110g canister cutting it too close?
Would going to a pot with a heat exchanger like the Firemaple Petrel pick me up enough efficiency to make any difference? Open to suggestions.
My hunt will be first week of Sept for 8 days at about 12,500'. My current stove setup is a Soto Windmaster Triflex (2.75 oz) with a MSR Titan Kettle (4.80 oz). The stove burns approximately 6.5 grams of fuel to boil 2 cups of water (1500' elevation, 70 degree, no wind) and I boil 2 cups twice per day. This would put me using 104 grams of fuel with no loss factor for wind or temp. Is trying to get by with a single 110g canister cutting it too close?
Would going to a pot with a heat exchanger like the Firemaple Petrel pick me up enough efficiency to make any difference? Open to suggestions.
Last edited: