Make your Tikka awesome for $85 - Full Frame Outdoors Tikka Stock Kit

[43.6N]

I’m trying out the system, and for 3D printed parts, they’re holding up very well.

I think this will be the new meta for factory division NRL setups.

 

[nm.otter]

I think this will be the new meta for factory division NRL setups.

...at least until they chamber the T3x Ace in 6mm Creedmoor.

 

[43.6N]

...at least until they chamber the T3x Ace in 6mm Creedmoor.

Yep

 

[Skidooboy]

Just a heads up on fitment of the bag rider. I have a Tikka Super Varmint with the original oem Tikka stock, the sling stud that goes into the stock is not a wood type screw. It is a machine type thread that threads into a threaded nut insert in the stock. The wood type screw that is provided is not the correct screw, for this stock. I will just run to the hardware store, to source the correct length and thread pitch screw for the insert. I just wanted everyone to be aware & warn others for future reference. I am not sure on the CTR or UPR type stocks but, the Super Varmint definitely has a different screw base than the "hunter" type stocks on most Tikka t3-t3x stocks.

I have sent an email to Full Frame Outdoors, regarding this as well. Ski

 

[SilkyJohnson]

I ordered the medium height cheek piece for my T3X CTR and it was a super easy no drilling needed swap. The CTR comes with a factory cheek piece and Full Frame Outdoors designed their cheek piece to line up with the factory hole.

I felt like the factory cheek piece was a little low for me to get a good view through my scope. The Full Frame cheek piece has a nice look to it and provided me with the cheek weld I wanted. I'm kicking myself a little bit because I am now wishing I bought the whole set.