Make your Tikka awesome for $85 - Full Frame Outdoors Tikka Stock Kit

[flyfisher117]

Is this 3D printed?

 

[MoeFaux]

Agreed. Interested in this as well. Hoping there was a video showing install. I’m going to assume it’s a self tapping screw through the top of the riser into the stock.

you pretty much nailed it. I emailed them to ask, and their reply had the following:

 

[yo_vinny]

I was literally just about to buy the Mountain Tactical cheek riser for my T3x but then I saw this thread and decided to roll the dice on this instead. I'll report back once I've had the chance to shoot it

 

[HighUintas]

Someone that is 3d printer savvy needs to copy this but mod it. Although it would require cutting the toe of your stock flat, I think it would functionally be better. Extend cheek to connect to higher butt pad. Cut toe flat. Bag rider would cover hole in toe and connect to the butt pad sort of like they did. Sides of rider could go up over stock about an inch for stability and mounting options. It may not be a big seller but if someone printed me one I'd buy it.

 

[nm.otter]

I was thinking along the same lines.

 

[blackhawk219]

Following as this looks like an interesting economical upgrade that could be a great value add. Looking forward to see people's experiences with it

 

[waspocrew]

Someone that is 3d printer savvy needs to copy this but mod it. Although it would require cutting the toe of your stock flat, I think it would functionally be better. Extend cheek to connect to higher butt pad. Cut toe flat. Bag rider would cover hole in toe and connect to the butt pad sort of like they did. Sides of rider could go up over stock about an inch for stability and mounting options. It may not be a big seller but if someone printed me one I'd buy it.

View attachment 998238

Agreed - a little modification and I think it’d do really well.

 

[Tahoe1305]

Maybe I missed it. But what recoil pad is compatible with the rear end….that isn’t stock if I’m not mistaken.

 

[Bowfinn]

Someone that is 3d printer savvy needs to copy this but mod it. Although it would require cutting the toe of your stock flat, I think it would functionally be better. Extend cheek to connect to higher butt pad. Cut toe flat. Bag rider would cover hole in toe and connect to the butt pad sort of like they did. Sides of rider could go up over stock about an inch for stability and mounting options. It may not be a big seller but if someone printed me one I'd buy it.

View attachment 998238

If you take the bottom piece you cut off you can just tape it on the top, and with a $12 pachmayr butt pad spacer you end up with something like this.

 

[Pilsner]

$24 shipping for $85 product. OUCH!

 

[OneGunTex]

Holding out for a Rokslider Review...

 

[Qholum37]

$24 shipping for $85 product. OUCH!

I ordered the kit last night and shipping was $7 and some change. Are you not in the lower 48?

 

[Pilsner]

I ordered the kit last night and shipping was $7 and some change. Are you not in the lower 48?

NW Arkansas. There wasn't even an option to pick from under SHIPPING. I dunno...

 

[BearGuy]

@Strider for the .223