Lets talk trimmers

[Ed3645]

LE Wilson, very accurate.

 

[nm.otter]

As a new reloader looking to minimize the effort while not investing in equipment I don't actually need, I'd appreciate some feedback on the advisability of what I recently posited in another thread:

If I'm only loading for one rifle, this could get stupid simple: Set FL sizing die so that a finished case will chamber easily, but one with a layer of Scotch tape on its heel gets tight. That should produce the maximum amount of case life with a minimum of slop.

 

[Dmoua]

Those with the three way trimmers, are you guys using it every brass prep to chamfer debur? Or are you only using them when trimming is necessary?

Only when trimming is needed. I have 21 times fired Alpha 6 Dasher brass that hasn’t needed trimming since the first initial trim.

 

[NorthIdahoDude]

The somewhat new (ish?) Frankford Arsenal Universal is what I use anymore. Fast, easy, works on any cartridge known to man. What's not to like?

 

[HuntHarder]

As a new reloader looking to minimize the effort while not investing in equipment I don't actually need, I'd appreciate some feedback on the advisability of what I recently posited in another thread:

It would possibly work, but I would want to confirm the thickness of the tape to be sure. I would just think a more fail proof method is a set of headboard gauges to put on your calipers. They are pretty inexpensive and can save you a bunch of money and headaches in the future.

It's a common practice to use tape on go and no go gauges, but might be a PITA to use it on brass you are sizing. You will find that brass springs back and want to spot check your bump often.

 

[Jayman_77]

Henderson since 2022, fast and highly repeatable.

 

[wind gypsy]

Those with the three way trimmers, are you guys using it every brass prep to chamfer debur? Or are you only using them when trimming is necessary?

Only when case grows enough to need trimming for me.

 

[HuntHarder]

New to the 3 in 1 game, but will only trim when needed. I have a RCBS case prep station that is quick on Chamferring.

 

[nm.otter]

I would just think a more fail proof method is a set of headboard gauges to put on your calipers. They are pretty inexpensive and can save you a bunch of money and headaches in the future.

Sure -- $40 or so all in. More importantly -- do I actually care about the specific measurement?

It would possibly work, but I would want to confirm the thickness of the tape to be sure.
...
It's a common practice to use tape on go and no go gauges, but might be a PITA to use it on brass you are sizing. You will find that brass springs back and want to spot check your bump often.

I'm only proposing to use it (either with two pieces of tape, or an extra few degrees of lock ring twist) to set my die for my chamber. Re-check every few hundred rounds just to be sure, but otherwise: FLS, load and shoot. If I minimize my shoulder bump every time, I should maximize my brass life.