Let's See Your Semi-Custom Tikka Builds

[AZBG]

T3X 22" 243
Stocky's VG
High Desert bottom metal
Salmon River rail
NF rings
SWFA 6x

Just need to send it to Kampfeld for a cut & thread

 

[Jmedin]

This is my 6 Dasher
20” CRB Barrel
McMillan Mtn Tracker LR
Atlasworx Alice bottom metal
Nightforce NX8 4-32 Mil c

 

[Havoc]

This rifle is a factory 6.5 PRC Tikka T3x Lite cut to 20" and threaded 9/16-24, set in a Stocky's Rokstok. I'm shooting a Silencerco Omega 36M suppressor fitted with an LS Wild cover, mounted on an Area419 Hellfire adapter. The stock is fitted with a Lumley Arms (Arctic) bottom metal and an Unknown Munitions bolt knob/handle. An SWFA 3-15x42mm gen 2 scope sits atop, mounted in UM medium rings and bubble level. I am currently using a Wilderness Systems Langlois Rhodesian Sling, but would prefer something with a non-slip shoulder pad.

I was having difficulty getting behind this rifle, until I added a Limbsaver Slip-on recoil pad to add some LOP to the stock. Looks like this stock needs to go back to UM for a spacer kit. This rifle comes fresh from the field with a "custom" ding in the objective bell and a touch of surface rust finish, after harvesting a spike bull .

What kind of speed are you getting out of that 20" barrel?

 

[Havoc]

Factory 6.5 PRC, Manner stock bedded by unknown, load development also by unknown. 124 Hammer Hunters 3200+ fps. Dead air Nomad Ti. Last three shot in the red.

 

[Ajsomp]

What kind of speed are you getting out of that 20" barrel?

I get 2735 roughly with factory 147 eldm.