If you wet tumble brass

[SloppyJ]

I roll them in a small cooler full of water and shake out all of the pins I can. Then I dump them onto a large towel on the floor and roll them around on it. I spread them out and run my magnet over them to get any remaining pins. From there, on a cookie sheet in the oven on its lowest setting for 30min. Done.

 

[deerhunter628]

Going to this one again. Is there really a shoe rack in a dryer LMAO who knew!

Most, maybe all dryers come with a shoe rack that you can put in. It keeps things from tumbling in the dryer. I didnt know either. I got the idea off of here and it works great. I didnt even know what that rack was for until i read about the shoe rack on here.

 

[BULLBLASTER]

Onto the annealing machine and they are dry after that.

 

[wind gypsy]

I've put them on a tray in oven or outside in the sun and wind, or just put on a towel and hit with a blow dryer. It all works. I didn't worry about putting it in an oven when I was single. Not sure I'd want something with any of those chemicals evaporating into my family oven now days.

Haven't wet tumbled in years though.