Howa Mini Rifles, Builds, and Upgrades

[UsAndThm]

I was finally able to get in an order for Jefferson Outdoors BDL style bottom metal. I hate magazines stick out the bottom of rifles.

I get that. I couldn't decide so I have both the magazine and bdl floorplate and use them in different circumstances. The magazine floorplate is mostly for the scout rifle vibe.

 

[Te Hopo]

Picked up a bargain 6.5 Grendel at a price that couldn't be refused.
Popped it into my spare Stockys Sporter along with a Jefferson Outdoors bottom metal with a cut down mag, the barrel will be getting trimmed to 15-16" so the reflex suppressor will be close up to the fore end.
Still deciding on the scope.

 

[JHcaliber9]

Hey all,


Just picked up a Howa Mini Stainless Carbon Stalker in .223 Rem with 1:8 twist as a lighter backpack/fun gun after running heavier stuff (smallest was 6.5 Creedmoor). Super light and handy, low recoil for more range time and precise shooting on game.


I don’t reload, so I’m looking for solid factory ammo recommendations. I know you guys have tons of experience (and this massive .22 caliber centerfire thread) on these for game. Looking for real-world input before taking it into the deer woods:


• Best factory loads / bullets for deer? (Especially ones that perform well in a 1:8 twist Howa Mini – 70-77gr range like TMKs, TSX, etc.)


• What velocities/distances to keep it ethical and effective? (Shot placement is key, but any rules of thumb on max range or energy?)


• Things to know switching from heavier calibers – wind, terminal performance quirks, preferred shot angles, etc.?


• Any Howa Mini specific tips or gotchas in the field?


• Will 5.56 ammo be safe in this .223 chambered rifle, or should I stick strictly to .223 Rem labeled ammo?


Appreciate any input from folks who’ve run similar setups. Planning lots of practice this summer. Thanks!

Rifle:

Howa mini 223 1:8 stainless 22” sporter
Stockys carbon fiber stock
Jefferson bottom metal

 

[Williammcinall]

Made some changes to my mini 20” 6 dasher
Notably added the check riser to the stock. It’s a Canterbury tikka riser kit. Heated it up with a heat gun to allow it to expand and fit the stockys stock. Replaced the nxs with a nx6 2-12x42