Howa Mini Rifles, Builds, and Upgrades

Thanks for posting. New to me too. I was looking at making a good one cause it was missing in the market. I’ll have to check it out.
I'm probably going to be ordering it up, curious what COAL i might get with it. At least it's in stock compared to others.
 
Contact to verify: Possum Hollow for the Mini in 6.5 #326, 223 #325

I used one of those four piece with plastic ends and an alu bushing for bolt bore and modified it. It was sitting unused in my junk box and I have no idea who made it. Had small diameter replaceable noses for different bores. I machined a smaller bushing for the bolt bore and used the original handle of the original bushing.
Thank you. I called them and they are hooking me up.
 
Thanks. I haven’t handled one.
Are they fairly rust resistant?
We have a 700 youth SPS that will get surface rust if there’s a chance of rain in the five day forecast.
 
Thanks. I haven’t handled one.
Are they fairly rust resistant?
We have a 700 youth SPS that will get surface rust if there’s a chance of rain in the five day forecast.
Very thin bluing, prone to rub marks. I love my minis but they are a budget rifle for sure.
I recently sold both my blued Minis and replaced them with Stainless ones, time will tell how they hold up.
 
Are these five round mags or modified ten rounders?
 

Attachments

  • Mag.jpg
    Mag.jpg
    456.1 KB · Views: 38
  • Mag2.jpg
    Mag2.jpg
    598.2 KB · Views: 37
Are these five round mags or modified ten rounders?
Modified 10 round mags
 
Like the mag mod a lot, did you cut the spring any or leave it full length? Joe
I just left it full length, it's a bit stiff when loading but I reckon the extra spring pressure is a benefit as the 5 round mag has never faltered.
I've had a couple issues with factory 10 round mags not poking the round up at the right angle
 
Contact to verify: Possum Hollow for the Mini in 6.5 #326, 223 #325

I used one of those four piece with plastic ends and an alu bushing for bolt bore and modified it. It was sitting unused in my junk box and I have no idea who made it. Had small diameter replaceable noses for different bores. I machined a smaller bushing for the bolt bore and used the original handle off the original bushing.

If I can bed one anyone can haha. Those bone stock tikkas with factory ammo sure make a fella question himself tinkering and loading for other things from time to time haha.

Like above said.
I was going to call, but I found it on Amazon. I’m lazy and it’s from them anyways.
The #326 works for my 6arc.
 
Back
Top