Howa Mini Rifles, Builds, and Upgrades

[General RE LEE]

Wanna sell the factory bottom plastic and magazine?

Jay

Right lol

I had to go to eBay and luckily some guy was selling a brand new factory bottom plastic.

Bottom plastic works and hell, it also works as a barrier stop.

 

[dieselchessy]

Felt left out by the Tikkas and there recoil pins. So modified some Leupold Backcountry Rings for some XL recoil pins.
Also whilst on the tikka binge I created the Howikka (with a couple extra slots)
View attachment 845047View attachment 845048

The Backcountry rings I have for Kimber 8400’s have that same hang over the ejection port. Seems an odd design. Maybe for long eyepiece scopes?

 

[jpndave]

Wanna sell the factory bottom plastic and magazine?

Jay

Sure, shoot me a PM and I'll give you my contact. It's new, never fired pulled from a barreled action. Was going to list it on eBay when I had an idea where to price it.

 

[jpndave]

The Backcountry rings I have for Kimber 8400’s have that same hang over the ejection port. Seems an odd design. Maybe for long eyepiece scopes?

Kimber 84M is the same way. I actually bought two sets to get the offset correct on mine. One will need to be re-drilled.

 

[Te Hopo]

Felt left out by the Tikkas and there recoil pins. So modified some Leupold Backcountry Rings for some XL recoil pins.
Also whilst on the tikka binge I created the Howikka (with a couple extra slots)
View attachment 845047View attachment 845048

Mate that looks very cool with those action cuts.
Ever removed some metal from the underside? As there's a fair chunk of metal hidden away

 

[Stocky]

The Backcountry rings I have for Kimber 8400’s have that same hang over the ejection port. Seems an odd design. Maybe for long eyepiece scopes?

Would they overhang on a Remington 700? These are 700 rings but I just don't trust talleys. The backcountry are 7075 and definitely a bit beefier. I'll make a custom set at some stage i think.

 

[Stocky]

Mate that looks very cool with those action cuts.
Ever removed some metal from the underside? As there's a fair chunk of metal hidden away

Not a huge amount on the bottom the area under the from flat is the support area for the lugs and would cause issues when bedding. You could remove some but it would be exceptionally difficult and only a little here and there. If the was one good spot I'd have done it. I just did it primarily for looks since I was already milling it. Still has the exact same foot print. And fits flush in the factory inlets.

 

[dieselchessy]

Would they overhang on a Remington 700? These are 700 rings but I just don't trust talleys. The backcountry are 7075 and definitely a bit beefier. I'll make a custom set at some stage i think.

I don’t know about on a 700. I tend to use rails on those.

 

[BART74]

Bought a 20" 6ARC barreled action off Brownells and built this up. Dropped it in an Elf Owl chassis with a folding Black Collar stock. I also had the barrel fluted which actually made it lighter than the 22" sporter i have in 223. Not as light as id hoped for, but happy with how it turned out. It ended up weighing the same as my 20" tikka sitting in a HNT26 chassis with the same scope, but significantly cheaper to put together. View attachment 805368View attachment 805369

man i like that rig