Holster for SG X-curve

[RAM190Hog]

Anyone have a good solution for carry on X curve w Glock?

I have an Ivory from my Exo pack. They are telling me it will fit on X curve with some new clips and "bunching" of the hip belt straps. Is there a holster that will fit better here?

 

[OregonCody]

Have you considered a chest holster? I have an SG pack as well and that’s what I plan on doing. I don’t think I could put a pistol on my hip and feel good about drawing quickly with how high I wear my hip belt.

 

[Kotaman]

The problem with putting anything on the belt of a SG (including a water bottle), is that is really “pulls” on those skinny straps And is constantly sagging. I use a chest holster with my SG.

 

[wind gypsy]

I just used a standard OWB clip on kydex holster and it worked fine with just a S&W shield 9. Not sure how it’d do with some heavier iron.

 

[thinhorn_AK]

Gunfighters inc kenai chest holster. When I use a leather guides choice holster it squeaks under the pack strap so I don’t mess with it. My kenai dosent squeak and with a Glock 20 fits fairly flush under my AGC bino pack.

 

[passinggas33]

I tried a few different things but in the end, went with a chest holster (gunfighter inc). I did use a cheap fabric holster for a while that had a belt clip but definitely pulled down and I was always worried about it falling off. I’m also a guy that likes to have my pistol on me when I take off my pack and the chest holster allows me to do that. Anyway, good luck.

 

[RAM190Hog]

Thanks for the info all. The Kenai looks good, but not sure about holster and binos over it. I use the Marsupial bino harness and looks like Razco makes a holster that attaches under it. I'm gonna check it out.

 

[doverpack12]

I use a Blackhawk Serpa with the belt attachment and narrow up the slider bars so they match the strap width. Carry a gen 3 glock 20 with 15 round mag filled with 200 grain hardcast. I have not noticed mine sagging at all and if it does the straps must be slipping. I tape all belt straps once my tension is set so they don’t work loose or come undone. Carried it 150-175 miles I. September and October this way without issue. I do also tie a short piece of rope to the slider near the main buckle from the holster so it can’t slide to the back part of the belt. In the past and since then I use the paddle holster attachment on KUIU hip belts.