DIY Draw Board for LCA EZ Green Press

[BigSky]

Nice work MM. I made my own draw board with a winch which had a cable rather than a strap. As I got to full draw trying to check timing I found my take up was too fast for my liking. I solved that by inserting a turnbuckle into my system which enabled very small incremental adjustments as I got close to the stops. I just provide this as a solution for others who may face the same problem.

 

[Mighty Mouse]

Nice job love that bow if it’s the VXR…

Yep, VXR 31.5

 

[sshhh]

The cheapest flux-cored wire Amazon sells (either .030” or .035”, can’t remember) on a Hobart Handler 140 with no gas.

Did you cut slots in the top of the two square tubings to be inserted? Just getting to this now and there is a plate and capscrews on the inside of the ez greens square tubing holding the jaws of the press in place.

Wondering if yours has this or if it flush.