Bowtech Prodigy axle to axle tolerance

[ChrisA]

My Prodigy limbs were replaced and the strings have about 75 shots. My axle to axle is 32 1/4 on the self side and 32 5/16 on the right side, right handed bow. The spec ATA is 32", and a quarter inch seems out of tolerance. I can't find any info but I believe its generally acceptable to be within 1/8".

The bottom cam has the cable barely inside of the rear timing dot on the cam. The top cam has cable almost outside the timing mark.

Is this acceptable or do I shorten 1/4" to the 32" spec?

I have a drawboard and can press the bow.

 

[dtrkyman]

I like to get draw length and draw weight as close to spec as possible, particularly draw length as scales have a variance. I agree a 1/4 inch is a bit much.

So get draw length on point and see where weight and axle fall.

My timing dots are not matching on either of my current Bowtechs, I like to get them towards the inner dot so my draw weight is up to max.

Difference from side to side is normal for cam lean/tune, thought typically shorter on the shelf side tunes best.

 

[ChrisA]

I like to get draw length and draw weight as close to spec as possible, particularly draw length as scales have a variance. I agree a 1/4 inch is a bit much.

So get draw length on point and see where weight and axle fall.

My timing dots are not matching on either of my current Bowtechs, I like to get them towards the inner dot so my draw weight is up to max.

Difference from side to side is normal for cam lean/tune, thought typically shorter on the shelf side tunes best.

Thanks. Great point on draw length and weight.