Best way to pull bullets?

[Vern400]

I had a rifle rebarelled and it doesn't like the same ammunition anymore. I've got a couple hundred cartridges to disassemble. It is hunting ammunition, fully sealed and waterproof. I've been shooting off this batch for at least 10 years, when suddenly my Barrel died. There's no way my kinetic bullet puller Will survive. I've got a couple pounds of reloader 15 tied up in these things and I want my powder back!

I use an RCBS press. What's the best tool, and way to pull these? and will the bullets be compromised?

I've never pulled many bullets, and zero after they're sealed.
Thanks!

 

[casey36]

I would use my kinetic. You seem opposed to that, so I would suggest a RCBS collet bullet puller for your press. Its used on a single stage so if you have Dillon or something, you may be out of luck.

 

[waspocrew]

Grip N Pull works well for me. I got tired of the noise and mess of a kinetic hammer.

 

[Axlrod]

Hornady cam lock is the fastest press mounted puller i have tried. Usually doesn't leave a mark on your bullet either.

 

[wapitibob]

rcbs collet bullet puller

 

[logem]

I'd use my Hornady Cam Lock puller for larger quantities.

I still like the my RCBS kinetic puller for lesser quantities since it guarantees no marks on the bullet. Just remember to remove the bullet from the puller before dumping the powder back into a 8lb jug, like I did today.

 

[Griffmax36]

I really like using the rcbs collet puller. I have also reused bullets with success.