Bergara’s New Suppressor?

[General RE LEE]

What are everyone’s thoughts on Bergara’s new can? It’s heavier than some models. Evidently it shoulders on the muzzle vs the shoulder of the barrel? I like it has vented and flat caps. Interesting.

 

[General RE LEE]

I’ve watched a couple videos. The video by X-Ring was a good demonstration. Evidently very little POI shift from can vs no can. I’m seeing lighter cans that are $200 less with swapable end caps.

 

[wind gypsy]

$1100 for a 13 ounce (I'd hope that includes the mount?) 6.5" Ti can is a hard sell these days.

I'm not sure how face mount would be better than a typical DT mount? Muzzle faces get lots of fouling on em if using a muzzle device, which would seem sub optimal. Maybe its just my skepticism.. but wouldn't be surprised if Bergara just machines the muzzle face more consistently than they do the muzzle threads and thats why they went this way.

 

[General RE LEE]

$1100 for a 13 ounce (I'd hope that includes the mount?) 6.5" Ti can is a hard sell these days.

I'm not sure how face mount would be better than a typical DT mount? Muzzle faces get lots of fouling on em if using a muzzle device, which would seem sub optimal. Maybe its just my skepticism.. but wouldn't be surprised if Bergara just machines the muzzle face more consistently than they do the muzzle threads and thats why they went this way.

Seems indexing off the crown would reduce poor alignment and baffle strikes no?

 

[wind gypsy]

Seems indexing off the crown would reduce poor alignment and baffle strikes no?

Why? Far as I can figure that is only true if the crown is machined more perpendicular to the bore than the shoulder of the muzzle threads. Why would one be more perpendicular than the other?

 

[General RE LEE]

Why? Far as I can figure that is only true if the crown is machined more perpendicular to the bore than the shoulder of the muzzle threads. Why would one be more perpendicular than the other?

Dunno. I’m kind of a tard so I think of illogical things.