Arken zero stop

[TradLife406]

I've got a couple epl4's. It seems when I line up my zero, after it tightens down it shift to the right about one mark. Any ideas?

 

[Austin Kaufman]

I have multiple scopes in various models from them and haven’t had any issues with that. Have you tried loosening all the screws and then turning it a hair past zero and retightening it down and it’ll slip to the right and be right on the zero line? Not sure if that’d work but just an idea!


Sent from my iPhone using Tapatalk

 

[TradLife406]

I have multiple scopes in various models from them and haven’t had any issues with that. Have you tried loosening all the screws and then turning it a hair past zero and retightening it down and it’ll slip to the right and be right on the zero line? Not sure if that’d work but just an idea!


Sent from my iPhone using Tapatalk

I tried that. I had it all sighted in yesterday just before dark. Shot great! Set my zero angle and everything. I was trying to be OCD about the zero. Must have bumped something because when I went to confirm we were good I was 3" high

So help me with the math. Say my "zero" setting is 1 mil. And I need to say dial three mils do then have to had an extra mil? Does it compound?

Luckily it's the 22 creed and my kids gun. Must shots will be inside 350. With this I should even have to dial until about 350 maybe 400. But I highly doubt they'll be taking a 400 shot especially in tomorrow's forecasted 30 mph winds.

 

[Austin Kaufman]

I tried that. I had it all sighted in yesterday just before dark. Shot great! Set my zero angle and everything. I was trying to be OCD about the zero. Must have bumped something because when I went to confirm we were good I was 3" high

So help me with the math. Say my "zero" setting is 1 mil. And I need to say dial three mils do then have to had an extra mil? Does it compound?

Luckily it's the 22 creed and my kids gun. Must shots will be inside 350. With this I should even have to dial until about 350 maybe 400. But I highly doubt they'll be taking a 400 shot especially in tomorrow's forecasted 30 mph winds.

I just went and looked at all of my 7 arkens (4 are EPL4s). The one I use the most and have put through hell is on the 6 arc. If you turn zero stop it slightly goes past zero, but never makes the actual turret “click” to move the elevation down a click. There is a slight tick past the zero but if it’s there or on the zero line it’s not impacted. I’ve shot that gun a lot and taken to 1300 yards and back down to zero and was dead on. I think it’s just slack in the turret but not actually clicking to move scope. Here is that scope if it goes past or if it’s on zero. It has never affected anything for me. Quite frankly I never noticed it.

Sent from my iPhone using Tapatalk