Anyone have a 6 ARC, 95 TMK, Varget load?

[JBradley500]

Can't seem to find a load for this. It will be in a single shot 14.5" pistol. Using Starline brass and CCI 450s for what it's worth.

Anyone have any experience or a source for suggested powder weights?

I also have h4350, but I assume that'll be too slow?

 

[waspocrew]

this is gas gun data (based off the listed PSI) and for the 95 LRX, but it’ll get you in the ballpark. This is from Hodgdons reloading site.

 

[Natebonebusta]

Can't seem to find a load for this. It will be in a single shot 14.5" pistol. Using Starline brass and CCI 450s for what it's worth.

Anyone have any experience or a source for suggested powder weights?

I also have h4350, but I assume that'll be too slow?

Well I just worked up a Varget load .5 grains over book max. Location is eastern NC so about sea level. No heavy bolt lift or signs of pressure that I could tell, but I personally wouldn’t go higher. This is a Howa mini 16” barrel. I’m satisfied, even if it’s at 50y.

Note that I used virgin brass for the first six pieces and number seven once fired. I saw a 25fps gain for that round.

 

[waspocrew]

Well I just worked up a Varget load .5 grains over book max. Location is eastern NC so about sea level. No heavy bolt lift or signs of pressure that I could tell, but I personally wouldn’t go higher. This is a Howa mini 16” barrel. I’m satisfied, even if it’s at 50y.

Note that I used virgin brass for the first six pieces and number seven once fired. I saw a 25fps gain for that round.
View attachment 1050700

That’ll do!

 

[JBradley500]

I loaded up mine at 28 grains at 2.26" then my pistol order got cancelled so I ended up with a 6.5 creedmoor instead. Now I have 100 rounds of 6 ARC and no gun lol. Typical.

 

[Natebonebusta]

I loaded up mine at 28 grains at 2.26" then my pistol order got cancelled so I ended up with a 6.5 creedmoor instead. Now I have 100 rounds of 6 ARC and no gun lol. Typical.

That’s a problem with a solvable solution…. Insert enabling here…