7prc + scythe ti

[adbaby]

I added a scythe ti to my 7prc and it has performed great. What are yall using on a 7prc?

 

[UKwildcatfan]

Muzzlebrake

 

[Brix8984]

It’s great until it looks like this.

 

[adbaby]

It’s great until it looks like this. View attachment 1092193

how many rounds did it take for you to get there? Thats crazy, it looks like direct thread?

 

[Brix8984]

how many rounds did it take for you to get there? Thats crazy, it looks like direct thread?

It’s a buddy of mines. I sold mine when I saw them blowing up on here. I would assume that is less than 100 rnds of 6.5 prc since he just recently got it.

 

[B_Reynolds_AK]

I added a scythe ti to my 7prc and it has performed great. What are yall using on a 7prc?

Just Don’t.

One shot from a 7 PRC after its previous life on CM based cartridges.

 

[Axlrod]

Shoulda read this first:

Thread 'SilencerCo Scythe Ti failures'

Dec 17, 2024

If you’ve experienced catastrophic failure of the Scythe Ti, please post the following:

1. Cartridge or cartridges used with approximate round count

2. Barrel length

3. Factory ammo, hand loads or both

4. Details of ammunition

5. Details of failure (to include failure point and pics)

• BjornF16
• Replies: 1,756
• Forum: Suppressors

• 

 

[Tdonat]

Mine was really sweet on a 7 saum, until it wasn’t

 

[adbaby]

Just Don’t.

One shot from a 7 PRC after its previous life on CM based cartridges.



View attachment 1092198

did silencerco make it right?

 

[ThreeOhSeven]

Silencer Co had mine back to me the same week, so yeah they made it right but they are still blowing up.

 

[Axlrod]

They sent me a new can same week.

 

[Tdonat]

Silencer Co had mine back to me the same week, so yeah they made it right but they are still blowing up.

Same here, they even replaced my sico suppressor cover. It lives on a 223 bolt gun now

 

[B_Reynolds_AK]

did silencerco make it right?

They made it weak AF and dangerous is what they made it.

 

[Gtscotty]

I guess to answer the OP, I've been running my Nomad Ti on my 7mm PRC for maybe 200-300 rds and have recently started using my EZ Altitude 30 on it as well. My Nomad had a weld penetration issue and separated on a short .280 AI, it's been fine on many rounds of 300 WSM, 6.5 CM, .308 and 7mm PRC since being repaired though.

 

[wind gypsy]

OP went from midnight to 6 with these replies