WeiserBucks
WKR
Never could have pulled it off without all that energy!
Not a chance. He’d be long gone with any other cartridge for sureNever could have pulled it off without all that energy!
Thanks man! JGS reamers will cut you anything you can dream up lol. They are also super helpful! In this specific case, I’d already had several of the Alex Wheeler 300 Norma Improved chambers done. So basically just called them, and them asked for the same case body specs, but with a neck for 7mm bullets.
Then I just used my same sizing and seating die, but just changes the neck bushings out on the sizing die.
That’s 15 MOA at 1000 for my elevation That’s insane.I’ve killed a couple coyotes and a couple aoudad with it so far. Started shooting the 180 ELDM’s with H1000 for 3160 FPS.
View attachment 705920
View attachment 705921
View attachment 705922
Tested N570 with 180 ELDM’s recently. Might shoot this when hunting season nears a little closer. Here’s the speeds as well as the case heads.
View attachment 705923
View attachment 705924
Hahaha pretty unreal!!That’s 15 MOA at 1000 for my elevation That’s insane.
I just run .001 neck tension. Anneal with an AMP annealer. Brush and moly the inside of the necks. Primal Rights primer seater with .002 crush. And weigh my powder charges to the closest kernel on a FX120i scaleThat SD is great, killer numbers on that Garmin. Care to share a bit about what setup you handload with?