6PRC ADG brass bushing size

[crich]

Did a quick search and came up short. Those that are loading ADG brass, what bushing size are you liking with .243 bullets?

Thinking about trying out the SAC PRC sizing die but oooo its pricey.

 

[T_Widdy]

.268 bushing then I run a .240 gauge pin mandrel on my adg. Gives me .239 id

 

[crich]

.268 bushing then I run a .240 gauge pin mandrel on my adg. Gives me .239 id

Found the "6mm prc" thread after I posted this and found your posts actually. No issues with a donut before switching to SAC dies?

 

[T_Widdy]

I don’t have the sac dies, I do use a sac bushing in a Redding die, they help with the doughnut I think. I build custom tapered bushings for doing the initial neck down that helps with doughnuts also. If I did it over again and now that sac has their setup I would probably go that route.

 

[crich]

A tapered bushing bushing seems like the way to go. Its not much of a neck down but did you have to neck turn?

 

[T_Widdy]

No I don’t neck turn.