6 SAS

[762 ULTRAMAGA]

Since when??

Typo Homeslice.. ADG

 

[762 ULTRAMAGA]

I got my dies last week and with Thanksgiving travel I only had a little time Sunday to work on loads.
Once my dies were setup I took 3 cases to run through load development, and continued reloading for my torture test.
They're at 8 reloads now without annealing and going strong

I've only tried 3 powder so far, H1000, 4831SC, and N555.
I'm just using standard large rifle primers (Fed 210).

Here's where I'm at so far with 115 Bergers:
54 grains H1000- 3012 fps with an SD of 12, cloverleaf 5 shot group at 100, slight bolt lift no ejector marks.

51 Grains N555- 2995 SD 5.8
Photo of 6 shot group, no pressure signs.

 

[wind gypsy]

Cool cartridge, would consider if lapua made brass for it with zero extra work needed

 

[762 ULTRAMAGA]

Cool cartridge, would consider if lapua made brass for it with zero extra work needed

Haha yeah if only they were taking orders..
I'm loving the effortless accuracy, can't wait to get my 25 SAS barrel in the next month or two.
I'll run it for NRL matches this season

 

[BBob]

Meet the 6 Short Action Suppressed (6 SAS

Would you mind sharing the reamer print?

 

[762 ULTRAMAGA]

Would you mind sharing the reamer print?

You bet

 

[BBob]

You bet

Awesome! Thank you! I need another project like a hole in my head but I’ve got a barrel, brass and an extra stock to start

And a wheelbarrow full of H-1000 in the cabinet

 

[WKR]

This is awesome
Very interested in your results with the 25

 

[762 ULTRAMAGA]

Awesome! Thank you! I need another project like a hole in my head but I’ve got a barrel, brass and an extra stock to start

And a wheelbarrow full of H-1000 in the cabinet

Nice!
Manson got my 25 SAS reamer to me in like 3 weeks, I think it was because they were tooled up already since it's the same dimensions as the 6 that they'd made.

 

[762 ULTRAMAGA]

This is awesome
Very interested in your results with the 25

McGowen just called me this afternoon to clarify a few details before chambing, should get it in two weeks!

 

[WKR]

McGowen just called me this afternoon to clarify a few details before chambing, should get it in two weeks!

Nice, I did pretty much the reverse of what you did with yours. Started with the 25 and now I'm looking at doing a 6mm version.

Would be pretty cool to get a reamer back as fast as you did.