6 PRC reloading

[T_Widdy]

Could you give more info on the sac bushing I need. Was it a custom bushing

Sent from my SM-G986W using Tapatalk

Short Action Customs Neck Sizing Die Bushing 268 Diameter

Short Action Customs Neck Sizer Die Bushings have minimized neck runout in cartridge brass in nearly every die tested. After attempting to eliminate and...

www.midwayusa.com

These are what I use with Redding or Hornady dies.

 

[Odd1out]

Short Action Customs Neck Sizing Die Bushing 268 Diameter

Short Action Customs Neck Sizer Die Bushings have minimized neck runout in cartridge brass in nearly every die tested. After attempting to eliminate and...

www.midwayusa.com

These are what I use with Redding or Hornady dies.

Just to make sure. .268

Sent from my SM-G986W using Tapatalk

 

[T_Widdy]

Just to make sure. .268

Sent from my SM-G986W using Tapatalk

That’s what I use, it gets me to around .238” id. Then I use a .240 expander mandrel. If you want to run just a bushing and not expand, it would be around a .270 bushing depending on what neck clearance you want

 

[mlevimadden]

Anyone using ADG brass or is everyone using Lapua?

 

[Muledeerfanatic]

I am using Petersen and an FL Redding bushing die with a .270 bushing and a .2415 ish mandrel

 

[Odd1out]

I'm gonna bite on barrel do u think fb at .140 or .180 is better? Going with a 1 in 7.5 twist. Hoping to run 107 to 116s. I know above post talks about the freebore issue. But i believe it was just a 7 twist.

Sent from my SM-G986W using Tapatalk

 

[Schmo]

I'm gonna bite on barrel do u think fb at .140 or .180 is better? Going with a 1 in 7.5 twist. Hoping to run 107 to 116s. I know above post talks about the freebore issue. But i believe it was just a 7 twist.

Sent from my SM-G986W using Tapatalk

Go .180” FB with 7.5 twist

 

[Odd1out]

Its gonna be 22inch long if that matters also

Sent from my SM-G986W using Tapatalk

 

[Schmo]

Its gonna be 22inch long if that matters also

Sent from my SM-G986W using Tapatalk

Yeah, no need for 7 twist

 

[Odd1out]

Yeah, no need for 7 twist

Thx for the help

Sent from my SM-G986W using Tapatalk

 

[Odd1out]

Anyone reach out to say peterson or adg about making 6prc brass?

Sent from my SM-G986W using Tapatalk

 

[BigDog00]

Will a 6.5 PRC Forester Seater die work for a 6 PRC. I would think if I swapped the seater stem it should work.

 

[Frozenlead]

There’s a few guys that mentioned running the 6.5 dies and 6.5stem with no issues. Back around page 6. Nothing forester specific, but it shouldn’t be an issue.

 

[Judd]

I called Redding to get a 6 stem for my 6.5 die...guy said the stem should be deep enough that the 6 bullet wouldn't bottom out and to see how it did. It's been perfect...dude saved me some money and didn't just sell me a stem to sell me a stem. Hats off to Redding, not the first time they've done me right either.