6 PRC reloading

[Titanmoose]

I’m awaiting my PBB 6 PRC barrel. Should be done in a couple weeks or so. 18” .750” taperless, 7.5 twist, diamond fluting. I had them add .040” freebore, so I’ll have a total of .180” FB.

I went with a SA (Atlas lite) so I was partially concerned that mag length / jump with above .140 would be too much for the 105-108’s. Or be hampered by OAL if you went with a tipped round.

I also know nothing so I wasn’t brave enough to add FB initially good thing barrels are cheap

 

[Runolfson]

I’m awaiting my PBB 6 PRC barrel. Should be done in a couple weeks or so. 18” .750” taperless, 7.5 twist, diamond fluting. I had them add .040” freebore, so I’ll have a total of .180” FB.

I ordered the same but in 20". What bullet are you planning to shoot? I was planning to shoot 108eldm will the standard .140fb be enough?

 

[Titanmoose]

I ordered the same but in 20". What bullet are you planning to shoot? I was planning to shoot 108eldm will the standard .140fb be enough?

I suspect it is. I don’t know for certain. You can always add FB.