3D Printed Bino Harness base for the Zulu 6

[Nicaburns]

Sorry, a little late to the game on this thread but just picked up a pair of these binos. I don’t have access to PM yet but would you be willing to share the STL file? Would love to print it off before I head out on my hunt in a few weeks

The only way to do this is for you to publicly post the email where you want the file to be sent. No way to attach an stl file to this thread

 

[Welldonecj7]

thats awesome do you know if it would fit with the fhf bino harness?

 

[Welldonecj7]

is the file available for download/purchase?

 

[Nicaburns]

I can send you the file if you give me your email but it may be a day or so delay due to travels

 

[bradybowen33]

Would you be interested in sharing the stl file?

 

[Nicaburns]

Would you be interested in sharing the stl file?

Just send me your email via PM and I’d be happy to

 

[Erint886]

Just send me your email via PM and I’d be happy to

I haven’t posted enough to send a PM yet and respectfully, I don’t want to spend $50 to upgrade my account. Would you be able to PM me for me to respond? Or would I be able to leave my email in the thread or is that frowned upon? I’d love to get that file for my dad- I think he would be stoked!

 

[Nicaburns]

If you can’t PM then we can’t send you PMs either. There are lots of scammers/bots hitting this site pretty hard now so I would not post my primary email… it’s up to you but that is the only way I could send it.

 

[Te Hopo]

I haven’t posted enough to send a PM yet and respectfully, I don’t want to spend $50 to upgrade my account. Would you be able to PM me for me to respond? Or would I be able to leave my email in the thread or is that frowned upon? I’d love to get that file for my dad- I think he would be stoked!

Contribute to a few more threads, make a few more posts and the PM feature will open up to you without needing to upgrade your account.

 

[Loshell]

I recently picked up a set of the Sig Zulu6 12x42 binoculars and ended up also needing a new bino harness since they were too tall to fit in my old AGC pouch. I got a Marsupial gear medium pouch setup based on recommendations here from a bunch of searches. Height wise they're a good fit but the pouch is wider than needed for these narrow binoculars. One of the other threads had a picture of a base that someone had 3D printed to hold the binoculars and give some extra storage. It was a good rainy day project to draw up and print, after a few revisions I ended up with a base that'll center the binos in the pouch and also carry a couple spare lithium AA's for the binoculars and spare CR2's for my rangefinder, along with a lighter.

Awesome to stumble on this. I don’t have messaging privileges yet. Any chance I could get the file PM’d to me?