22 Creedmoor H4350 starting point…

270quest

WKR
Joined
Jan 31, 2017
Messages
717
Location
Boise, Idaho
Going to be slinging 80 grain ELDXs…. What would be a good starting load? Thinking around 35-36 grains and probably working up to around 39-40????

Fed 210s in Hornady brass….
 
Joined
Sep 30, 2019
Messages
1,013
Appears to be a smart start. Did not know about the 80 ELD-X till I saw this post.

For my first charge test, notes for 75 ELD-M show that I started at 41.5 grains of H4350 and went up to 43.5 with no pressure signs @ 3,546 fps. Settled at 42.5 and 3,454 fps. Had my load dialed-in after my first 15 rounds. Never bothered to test seating, so stayed @ .030" off.

Specs are 22" Benchmark w/1:8" rot, Alpha SRP brass, CCI 450 srp.

Pic from 2022 is my second charge test (2 shots each charge) moved out to 300 yards. All 10 loads fit within .73" POI @ 300 with 5 different charges. Can shoot 77 LRX even faster @ .050" off. Encouragement is H4350 has worked exceptionally well in any Creedmoor chambering I've been familiar with.
IMG_0036.JPG
 

FB Trout

Lil-Rokslider
Joined
Jan 17, 2024
Messages
161
I’m at 39.5 grains of H4350 with 88 ELDm with Alpha LRP brass and fed 210s. I’d say your starting point is spot on and you’ll likely have some wiggle room up in the 39-40 range.
 

Clarktar

WKR
Joined
Aug 30, 2013
Messages
4,311
Location
AK
Just inherited two Ruger 10/22s. Wondering if I can turn one of them into a 22 CM

Sent from my SM-G973U using Tapatalk
 

hdc77

Lil-Rokslider
Classified Approved
Joined
Aug 28, 2022
Messages
119
Location
McAllen, TX
I just went though this with a 22
CM, found pressure at 41 gr H4350 in my barrel, started at 35 gr. Afterwards, I switched to H4831SC. My rifle liked better
 
Top