I built a turkey gun off a 20ga Yildiz youth over under. It has a selector switch and I choke one barrel for the normal 30-50 yard shots and the other barrel with IC for when one sneaks in too close. I run a red dot and #9 TSS handload a. The gun is very short and light.
Sent from my iPhone...
Yes, Harvester Evo. It has a serial number before the recall. Silencer Co took care of me with no issues and I was happy to deal with them and have a scythe sitting in jail. It was a 22” 300wm 1gr below Hornady book max. It was a perfectly clean separation at the weld, no jagged edges to...
I honestly don’t know, it looks like it could have been a failed weld. I couldn’t find the rest of it to verify or rule out a baffle strike. It was scary though.
Sent from my iPhone using Tapatalk
To be honest my suppressor blew up shooting my 300wm not long after that post and I just received it back. That kinda but a damper on things.
Sent from my iPhone using Tapatalk
Thanks freaking scary, it honestly makes me scared to shoot this thing again in the 300wm. Worst is I have a Scythe Ti I’m waiting on that I purchased for this particular rifle.
Sent from my iPhone using Tapatalk
It is a Harvester Evo. It was direct threaded on a gun that had just been threaded. It was till tight when it happened. Obviously my first thought was a baffle strike due to a bad thread job. But this guy has a great reputation and I have verified the work with a rod by a third party. No issues...
It was before the recall, not sure the manufacturer date but it was purchased in April of 22, I took possession in February 23.
Sent from my iPhone using Tapatalk
Well this is the issue, the original question was rhetorical. This happened to my Harvester after 3 shots with my 22” 300wm. It blew apart at the weld and I never found the other part. I don’t think it was a baffle strike because all three shots were in the bullseye.
To be clear I am not...
Has anyone put a significant number of 300wm rounds through a Harvester Evo? It is rated for 300wm with a 20” barrel I have 22” barrel pushing a a near max charge behind a 208gr eldm. I don’t see any pressure signs and am 1gr below book max. Is this something I need to be concerned about riding...
So all these quick approvals are all individual? If so that sucks because I have 2 I’m waiting on in single shot trusts.
Sent from my iPhone using Tapatalk