Your best (cheap?) organization tips and tricks

dårlig jeger

Lil-Rokslider
Joined
Nov 23, 2025
Messages
150
Just getting into reloading and it's a mess. Brass, dies, powder, primers, gages, tools, it's a lot to organize.

I'm looking for ideas (photos!) of ways to keep things clean and accessible. I usually load for one cartridge at a time but I have 5-6 total I load for.

Any tips for brass bins, tool racks, cabinet setups, etc., would be greatly appreciated!
 
For loading blocks, if you use pullets for a muzzleloader you can cut the top off the bax and use that for a loading block. Works great for 308/3006 sized cases and smaller.
 
I have a 4 tier shelving unit I got from Home Depot. I have some of the 7 gal HDX storage bins for bigger stuff and some of the 6.5 qt bins for small items. It works for my layout and has helped a ton keeping the bench from becoming a cluttered mess.

I just have to get better at being consistent and not letting mu die boxes sit on the bench and put them back in the storage bin they belong in.
 
Put everything you have in a large box. Walk into your reloading room when it's pitch black.
When you are near your bench, take the box and toss everything you have in it and toss it all over the place.
Then turn on your lights, look at your bench..........now you are an organized reloader.

Randy
 
Get yourself a little Craftsman tool box or something with drawers for your tools. Most reloaders have 10x more crap than they need. Go to a local short range benchrest match sometime and watch those guys load at the range with just a few basic tools. It doesn't take much to load good ammo.

Buy powder by the jug. It takes up a fraction of the storage space and you actually have enough to practice with and carry you through shortages.
 
I make sure to clearly label everything with a sticky note otherwise I have no idea what’s going on when I get to the bench because it’s often weeks or months between reloading sessions.

All my dies are labeled for the load the are set up for, no guessing. The other day I sat down to do something and there was a box of brass sitting there that I had no recollection of what was going on with it. Luckily I’d made a note just saying it was sized and prepped and the date I’d done the work.

Also when it’s time to trash something, I toss it right away so I don’t accidentally use it again or something dumb.

I’ve also more or less started making only one load per gun, it makes things much easier and it makes more sense than making 4 different rounds for 30-06 for example.
 
I’ve also more or less started making only one load per gun, it makes things much easier and it makes more sense than making 4 different rounds for 30-06 for example.

Same here. I grew up on those 'do everything with a 30-06' articles. That's for the birds. Too much stuff to stock and nothing's ever sighted in and ready to go.
 
Back
Top