Mighty Mouse
WKR
Glad you were able to get it tuned. Feels good to do it yourself.So I got my synuum press, which btw is nice! Perfect for small tuning jobs like this.
I had to put 2 full turns into the left and 2 out the right to get the cam lean corrected. Now it’s perfectly aligned with top cam at full draw and the arrow against the cam lines up perfectly.
At full draw it was like the center pic but about 1/2 as bad as the lean in the pic below.
Micro adjusted the rest and it’s a nearly perfect bullet hole now.
Before the yoke tuning…
My only other issue is I have to anchor perfectly and pull hard into the stop to ensure I’m not inducing lean. I’m on a #2 cam which maxes out at 28” draw and I’m actually about 28.5”. I might swap to #3 cams to get my anchor a little further back but hate to lose that 7fps from the #3 .
Anyway thanks for all the tips guys!! It was fun to get it right myself and know what’s happening via test/tune.
Sent from my iPhone using Tapatalk
FYI you'll need a new string if you swap cams. I believe your draw weight will also change significantly if you swap cams without also swapping the limbs. You could try an extra long d-loop to make the #2 cam fit you better.