Trijicon accupoint 3-9 mounting length?

[thinhorn_AK]

Does anybody have a 3-9 accupoint they could give me a mounting length measurement for? Can’t seem to find it online.

Thank you!

 

[TxxAgg]

Here you go

https://www.trijicon.com/uploads/product-uploads/product-downloads/AccuPoint_Dimension_Chart_2020.pdf

 

[thinhorn_AK]

Here you go

https://www.trijicon.com/uploads/product-uploads/product-downloads/AccuPoint_Dimension_Chart_2020.pdf

Thank you, saved me some money.

 

[BAKPAKR]

What were you going to mount it on?

 

[thinhorn_AK]

What were you going to mount it on?

A Kimber mountain ascent 300 win mag. I’m trying to not use a rail.

Right now it has a trijicon tenmile HX 3-18 on it but I was looking for something a bit more basic.

 

[BAKPAKR]

Here is mine in extended Talley lows on a Remington 700 LA. Clearance is minimal in a couple of spots.

 

[thinhorn_AK]

Here is mine in extended Talley lows on a Remington 700 LA. Clearance is minimal in a couple of spots.

View attachment 601314

After looking at more of those trijicon schematics (not sure why I couldn’t find them earlier) I see my tenmile HX has a 6.1” mounting length and it’s a tight fit not much ore than a 1/4” of movement possible. The accupoint has the same length as my shv 3-10 which won’t fit on the rifle.

Right now o have the following mounts to try:

-warne mtn tech rail
-leupold backcountry rail (exactly like the warne)
-warne maxima 2 piece bases
-warne mountain tech rings
-talley lightweight rings.

I may throw the talleys on and see if the thinner width allows a bit of room.

 

[BAKPAKR]

Since there is no built in MOA on the Talleys, can you flip the position of the front ring to give you more room to play with (so the actual ring is over the rear screw hole instead of the front one?

 

[thinhorn_AK]

Since there is no built in MOA on the Talleys, can you flip the position of the front ring to give you more room to play with (so the actual ring is over the rear screw hole instead of the front one?

That’s what I’m going to try.

 

[Macintosh]

Fwiw I just put a credo 3-9 on my wifes kimber 84m in talley lows. The mounts are flipped to allow the scope to slide as far back as possible to have eye relief correct, and its there but barely.

 

[Weldor]

Just put a 3x9 Credo on my Savage 308 predator ultra light. I had to use a rail to get proper eye relief for me. 14" lop. Rear ring is in last pic slot and carrying alittle over the back of the rail by about 1/8". After the season I'm going to check out some offset rings? Would prefer to mount it closer to the action and no rail. Any recomendations?