Torque Recommendations - Tikka + Sportsmatch + Trijicon

[Skydog]

I'm setting up a rifle/scope that I purchased a while back and need torque recommendations for bases, rings and action screws. I've tried searching here, other forums, and the manufacturers' websites...but finding inconsistent info. I've already cleaned, degreased everything with brake cleaner, etc.

Here's what I have...

1) Tikka T3X .243 Winchester - factory wood stock and factory (plastic/polymer) trigger housing:
- What should the torque be on the front and rear action screws? These are T25 Torx screws.

2) Trijicon Huron 3-9X40 (1 inch tube) - mounting directly to the Tikka integral dovetail rail using Sportsmatch TO48C mounts:
- What should the torque be on the 3mm hex screws that attach the bases/bottom half of the ring to the integral rail?
- What should the torque be on the 3mm hex screws that attach the top half of the ring to the bottom half?

And how would the torque recommendations change (if at all) based on whether one is using versus not using Loctite?

I'm using a Wheeler F.A.T. Wrench to try to get the torque as close as possible.

Thank you!

 

[The Harbor Master]

You will get recommendations all over the board for action screw torque. Generally you will hear anywhere from 45-65 in lbs. 65 in lbs has been shown at times to be too much for the factory plastic. Unusual, but it does happen. Anecdotally, I try to get as close to 65 as I can before getting nervous about it. I use 55 in lbs on my .223 and 65in lbs on my 7mm with no issue.

There's been a few threads on here about loctite vs nail polish vs paint pen. This debate creates arguments that get WAY into the weeds for dummies like me (though I'm sure some appreciate the nuance). Those threads are into the dozens of pages last I looked. I torque to factory spec with or without locking agent, no issues.