Too short trim length won’t eject?

Mikido

WKR
Joined
Dec 14, 2020
Messages
865
Trimmed 308 below the min, and they won’t eject. Does that make sense? The brass is actually 7.62, everything else 308. Thanks
 
OP
Mikido

Mikido

WKR
Joined
Dec 14, 2020
Messages
865
I would bet you bumped the shoulder back too far.
No I tested it a few times. Def below 2.000 the shell won’t return with the bolt. Falls out when vertical. 2.000>2.025ish smooth operation. >2.035 very difficult
 

BrBa

Lil-Rokslider
Joined
Sep 20, 2023
Messages
133
According to the saami drawing, .308 headspaces on the shoulder, not the case mouth.
 
Joined
Nov 12, 2020
Messages
1,375
Trim length is 2.005 and you could easily go to 2.990. You could cut the hole neck off and it wouldn’t have any bearing on the ability to extract. 2.035 and the case mouth is .010 over max case length, and I’d expect some issues.
 
Joined
Jul 6, 2022
Messages
571
always a good idea to have a 308 gauge block to check rounds. also not a bad idea to have go - no go gauges for your rifle.
trim length doesn't affect extraction, but bumping shoulder back too far will. as will improper headspace.
 

Lawnboi

WKR
Joined
Mar 2, 2012
Messages
8,502
Location
North Central Wi
Either something is wrong with the extractor in your bolt, or you sized so much that the round goes so deep that the extractor cannot grab the rim.

Either way don’t fire one, will be a pain to get out if it’s even safe.
 

rayporter

WKR
Joined
Jul 3, 2014
Messages
4,417
Location
arkansas or ohio
if you have the tools measure shoulder bump. if you dont have the tool use a 45 case [most any pistol case works] over the neck and measure base of case to base of pistol case. do this on a fired unsized case and one you have sized.

this will tell you how far back you have bumped the shoulder.
 
Top