I purchased a Timney Elite Hunter to upgrade the trigger in my Remington M700 SPS 30-06. After installing it I noticed the bolt was difficult to manipulate and I was underwhelmed by the trigger pull. It measured about 3.5# but my stock 6# trigger felt better. I called Timney and they said that I have one of the “rare actions that is a tighter tolerance than most” so I need to remove the sear and file it down. I asked if they had an instructional video or anything to walk me through it but they said to just remove the pin by the sear and it’ll come apart. I’m not exactly confident that this will improve the trigger pull but will only reduce the friction on the bolt so I’m hesitant to take a file to it. I’m considering sending it back and getting a Trigger Tech or Geissele.
Does anyone have any experience with the Elite Hunter or have any recommendations?
Does anyone have any experience with the Elite Hunter or have any recommendations?